Dragonfly Earrings
Supplies
2 small Hill Tribe Silver dragonfly pendants
2 disk beads - Humblebeads
2 8mm smoky quartz beads
4 6mm pearls
4 8mm faceted pearls
4 4mm crystals
24 nickel seed beads, size 11
2 5mm flat spacers
2 6mm flat spacers
2 crimp beads
2 silver earring wires
Beading wire
Crimping Pliers
Wire Nippers
1. Cut two 6 inch lengths of beading wire.
2. On one of the beading wires, string on the dragonfly and let it fall to the center of the wire.
3. On one side string a 6mm pearl, seed bead, 8mm pearl, seed bead, crystal, seed bead. Repeat pattern on the other side of the dragonfly.
4. String both sides of the wire through a 5mm spacer, disk bead, 6mm spacer, smoky quartz bead and a crimp bead.
5. On each wire string 3 seed beads.
6. Loop each side into the opposite side of seed beads to form a little loop on the top. Thread the beading wire back through the crimp bead and smoky quartz bead.
7. Pull the beading wires very tight so only a small amount of the beading wire shows on the top. Crimp the crimp bead. Nip of the excess wire as close to the smoky quartz bead as possible. Tuck the end of the wires down into the spacer bead.
8. Add earwire and repeat the process to create the second earring.
Note: The wires must be pulled very tight before crimping for the dragonfly to lay properly. This may take some patience and a pair of pliers!

I created this pair of earrings as a companion for my Eclectic Dragonfly Necklace that first appeared in BeadStyle magazine. The necklace went on to make an appearance on PBS' Beads, Baubles and Jewels. It can now be seen in BeadStyle's
Easy Beading Vol. 4
.
This project is part of
Ornament Thursday. A collection of designers that tackles a theme each month in a marathon of creativity. To check out the other projects visit the links below.